I'm referring mainly to the relation of sample line stations & corridor frequency stations. Currently if I want a section view to display correctly at 200+00 I have to have:
1) sample line @ 200+00.00
2) section view @ 200+00.00 (generated from a sample line)
3) corridor frequency @ 200+00.00
When adding sample lines & or corridor frequencies, there is an option to either key in the station or to physically "pick" the point in model space.
If I key in the station for both sample line & frequency, everything is kosher.
If I "pick" the point in model space instead, the program sees that station identification out to 200+00.00000001 for the sample line & 200+00.0001 for the frequency, causing a discrepancy in the station value; resulting in the section not looking like it should because the sample line & the frequency are technically not the same station. What I want the program to do is to recognize the point "picked" in models space at 2 decimal place precision. OR to recognize any station >199+99.5 & <200+00.4 as 200+00, so that if my frequency & sample line are only off by .000001 it will still recognize the break lines from inserting the assembly at said station.
I have not found where to change this precision...
Jessica Miller
Design Technician
CEC Corporation
4555 West Memorial Road, Oklahoma City, OK 73142
T: 405.753.4200
Dir: 405.753.4616
www.connectcec.com