PART OF ASSEMBLY NOT SHOWING ON CORRIDOR

[bforr]

C3D 2026

Built an assembly including travel lanes, curbs, a generic  LinkOffsetAndSlope, and a sidewalk.  Then created a corridor from profile.  Only the travel lanes and curbs are part of the corridor.  (See attached) I've checked the assembly properties and the link and sidewalk are listed. I've checked the corridor properties and the code set.  All seem ok.  I've created a few corridors in the past that worked, but am not the most experienced.

Can someone point out my misstep?

[bforr]

and too add to the mystery.  corridor in object viewer shows the linkoffset and sidewalk inverted so to speak.  They turn inward toward the assembly centerline.  Attached is an image of the object viewer.  And in the section view, using top as my corridor surface, the section shows the sidewalk in the street.

[bforr · Accepted solution]

Well.  We couldn't wrap our heads around why the link and sidewalk were turning inward.  Looked at the help for sidewalks, saw the buffer input, deleted the linkoffsetandslope, added the buffer to the sidwalk parameters, it automatically connected to back of curb, and now it looks as it should.  See attached.  We don't understand why the linkoffsetandslope didn't work.  Probably input error, but couldn't find it.

Now we just need to figure out how to put a slope on the sidewalk and associated buffer.  It talks about slope in the sidewalk help, but doesn't say where.