- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
how do you convert xyz files that is lidar done in LCC to UTM? project go across nad83 zone 10 and 11.
only info i have on this LCC is see attached. not the your usual Northing Easting shift, scale, etc type.
i look it up it's like a cone thing from north pole so i don't think it's that simple to convert.
ideally i need to feed these xyz files and export to UTM xyz.
not sure this lambert coordinate have other locations this is in canada for transmountain pipeline. in Civil 3d there are this under the Canada country and grid. also a few other var1, 2, 3, 4, etc for this canada LCC.
googled quite a bit normally find some answers but this one has been tricky.
Stantec
Dell Precision 5530, Prism M320PU, C3D 14/17/19
Dell Precision 5530, Prism M320PU, C3D 14/17/19
Solved! Go to Solution.