Hello,
Inside the attached drawing, I am trying to "combine" the "LC1" and "LC1A" and the "LC3" and "LC3A" gradings/surfaces.
In my opinion, the best way to do this would be to us one feature line/corridor with a 90 degree angle in it. However, whenever performing this command with a 90 degree angle in the feature line, I end up with gaps or incorrect contours in the corners where the gradings meet.
Does anyone have advice on the best way to complete this operation? How would you go about combining these two surfaces so that it creates one continuous trench rather than two separate trenches.
All help is appreciated.
Thanks,
Dustin
