Corridor fill is wrong

[robbieBDP]

Hi all

I'm trying to model a corridor where there is a substantial amount of fill over a valley. However, using the Daylightmultiintercept subassembly, I am getting what looks to be spurious fill information, where in some areas the fill slope reaches way beyond what I'd expect to see (hundreds of meters). See drawing attached and circled areas below.

Fairly new to this so I expect I'm doing something wrong, perhaps using the wrong subassembly. I am modelling a simple wind farm access road with a 30 degree cut/fill slope.

Any help much appreciated.

Thanks

[Jeew-m]

Hi,

I think you are using the wrong daylight. Your assembly supports multiple intercepts of daylights. It goes up to 10 intercepts.

Use something like daylight general as daylight assembly.

Thanks

[robbieBDP]

Thank you.