Computing Materials

[Bkilen]

Hello,

I'm computing materials and my surfaces are not showing up when I go to put them in.. What step did I miss.... Attached is the file....

Brad

[tcorey · Accepted solution]

The surfaces are not designated as data sources for the sample lines.

Select any Sample Line on the screen. On the Ribbon, select Sample More Sources. Add your surfaces.

[Bkilen]

Hello,

I finally got my surfaces to show in Materials However I am trying to get my cross sections to be regular.. I ran them many times.. Now what they do is pile up as you will see in the photo attached.. I used the same template it worked then I cleared and ran it again many times.. What causes this type of result.. Attached is the file to view..

Thanks,

Brad

[Bkilen]

Hello,

I finally got my surfaces to show in Materials However I am trying to get my cross sections to be regular.. I ran them many times.. Now what they do is pile up as you will see in the photo attached.. I used the same template it worked then I cleared and ran it again many times.. What causes this type of result.. Attached is the file to view..

Thanks,

Brad

[tcorey]

New question, start a new thread. That will help future searchers who have the same problem.

[ellbaz73]

sorry

but i have the same problem

i do as u shown exactly

but it does not appear

[wfberry]

Read this over and you can see what you left out.

Bill

[wfberry]

Read this over and you can see what you left out.

Bill

[wfberry]

Sorry guys.

I don't know how I sent all these extra items.

Bill

[fcernst]

Here you go..

[Bkilen]

Hey, try checking the drawing scale if it calls for 1:50 etc set that,  there is also a refresh in the toolbox to refresh the sections. GOOD LUCK!

[Bkilen]

Also check your settings for the display by right clicking on the section view. 

[llorcajr]

Is there anyone can help me with this...