Dear all,
During the last week I have been simulating different situations in a model. I try to verify that there is no by-pass between the discharge of some chillers and the aspiration of some generators. For this, I use the famous box (7D, 7D and 5D). I have used a mass in situ to model this volume of control because I have seen that it offers better results than if we use walls. However, suddenly, it doesn't simulate because it always reports a meshing error. I have tried the different options that come in the error message and I have generated diferent paralell models in case it was due to some kind of internal error.
Any help would be appreciated.
Best regards,
Adrián Rodríguez
