Community
BIM 360 Glue Forum
Welcome to Autodesk’s BIM 360 Glue Forums. Share your knowledge, ask questions, and explore popular BIM 360 Glue topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

IFC models fail to glue

1 REPLY 1
Reply
Message 1 of 2
rfranklinpagethink
801 Views, 1 Reply

IFC models fail to glue

I've been sectioning this IFC model, among others, down to less than a 1 GB --- and it still says gluing, or then says (3 hours later) fails to glue.

 

What is the file limit per model with BIM Glue? Is there a file limit?

 

How can I get this model to glue? I've glued other IFC models to the project --- some of them actually glued.

 

All these need to be updated weekly, so would prefer the model glue when "gluing."

rfranklinpagethink_0-1694067210700.png

 

1 REPLY 1
Message 2 of 2

I'm at my wit's end with BIM Glue! I've shrunk this IFC model down to under 1 GB, meticulously sectioning it out, and yet... it keeps saying "gluing" but never finishes, or throws a fail error after 3 agonizing hours.

Are there any hidden file limits for Glue models? Or some other cryptic reason it's choking on this specific file?

Adding to the pain, I've glued other IFC models just fine to the same project! So what's the deal with this one?

It's crucial for all models to be updated weekly, so this "gluing" limbo is a total roadblock. Any suggestions, BIM wizards?

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report