Block insertion point has changed from the set basepoint

[Anonymous]

I have a drawing where all of my classic and dynamic blocks are saved, and are referenced to a series of tool palettes. All are saved in a Catalogue within the Content Browser. All blocks had the proper base point set, but just recently, they have all defaulted for top-left of the block. I attempted to enter into the dependency drawing and reset the basepoint to the proper location, but that did not override the default. I also deleted all palettes and reloaded them to no avail. Does anyone have a solution to this problem? Thanks!

[pendean]

Are you sure the file you dragged those blocks into did not already have the same named blocks in them with this problem already in place?

[Anonymous]

The file was created from scratch and was working perfectly fine (with the
proper basepoint) for the last 5 months, and then all of a sudden changed
to default the basepoint as the top left of the block.

[Anonymous · Accepted solution]

Figured it out! Not sure how this occurred, but below is the solution:

- Select any block or device from the palette.

- In the command line, hit 'J' for justification.

- Within the justification setting, type 'IP' for insertion point. 

This change should propagate to all blocks. Hopefully someone finds this useful.