AutoCAD LT General Discussion

AutoCAD LT General Discussion

Reply
Accepted Solution

Hatch Files

216 Views, 3 Replies
02-08-2013 02:07 AM

I just have a quick and probably simple question. I am new to writing .pat code and I am getting an error message when I try and load my hatch. It tells me error in line 4. This is my code for a 240 by 160 concrete block paving stone.

*Herringbone, 'Herringbone-pattern' 160x240mm brick/paving @45deg.
90,0,0,400,80,320,-640
90,240,0,400,80,160,-800
0,-160,0,560,80,400,-560

It looks good in the preview, can someone help please.

Did you press enter at the end of line 4 in your .pat file. Autocad is expecting a line return at the end of the file. 

Advisor
831 Posts
134 Kudos
78 Solutions
Post 2 of 4

Re: Hatch Files

02-08-2013 02:47 AM in reply to: Leo.a.Reilly

Did you press enter at the end of line 4 in your .pat file. Autocad is expecting a line return at the end of the file. 

Regards Steven Gray
Setting Out (Joinery Manufacturing)
Autocad 2013LT
Windows 7 professional

Re: Hatch Files

02-08-2013 02:57 AM in reply to: steven-g
Yes that worked, Thanks I have never written code before ------ Scanned by The Email Laundry http://www.theemaillaundry.com
Highlighted
AUTODESK EXPERT ELITE
8409 Posts
484 Kudos
409 Solutions
Post 4 of 4

Re: Hatch Files

02-08-2013 04:38 AM in reply to: Leo.a.Reilly

Please mark Steven Gray's post as Solution



Regards, Charles Shade           
CSHADEDESIGN | AUTOCAD LT | LT-KB | DYNAMIC BLOCKS
 
Please mark Accept as Solution if your question is answered. Kudos gladly accepted.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Community Alert

The Autodesk Community Forums, Blogs, and Idea Boards will be in read only mode starting on 2/12 at 9PM PST through 12PM PST on 2/13. Please see the following for more information: Site Maintenance Notification

Announcements
Community Alert | The Autodesk Community Forums, Blogs, and Idea Boards will be in read only mode starting on 2/12 at 9PM PST through 12PM PST on 2/13. Please see the following for more information: Site Maintenance Notification