Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

Trouble with sculpting surfaces

Anonymous

Trouble with sculpting surfaces

Anonymous
No aplicable

I have AutoCAD 2016 student version installed. I've included a screenshot of the drawing I'm working on. When I try to apply a COINCIDENT or TANGENT constraint to the ARC's right end of the horizontal line, I keep getting a message saying it will over constrain the drawing. I had no problem applying a COINCIDENT constraint to the left end of the ARC as you can see. Is there a solution to this problem? Thanks!

0 Me gusta
Responder
Soluciones aceptadas (1)
293 Vistas
3 Respuestas
Respuestas (3)

Alfred.NESWADBA
Consultant
Consultant

Hi,

 

it's much easier if you upload the dwg-file, we can't test constraints in your screenshot.

 

- alfred -

------------------------------------------------------------------------------------
Alfred NESWADBA
ISH-Solutions GmbH / Ingenieur Studio HOLLAUS
www.ish-solutions.at ... blog.ish-solutions.at ... LinkedIn ... CDay 2025
------------------------------------------------------------------------------------

(not an Autodesk consultant)
0 Me gusta

j.palmeL29YX
Mentor
Mentor
Solución aceptada

You have too many restrictions in your geometrie. As far I can see it should be possible after deleting the rad3 or the rad 1 or the rad2 or ...  We don't know your intention. And yes - post a dwg and tell us what you need.

 

cadder

Jürgen Palme
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.

EESignature

Anonymous
No aplicable

I figured out a solution on my own. All I had to do was trim the right end of the arc. Thanks for your input.

0 Me gusta