Tracking turned off?
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
Hi,
I had to reset autocad 2020 to bring back a glitched dynamic input box. Unfortunately, the setting where you can make a point on a line, with a little 'X' has disappeared. To explain further say If I had two equidistance lines at a perpendicular angle, both joined at the end of the line to create a triangle with no hypotenuse, I would place my cursor on the opposite end of each line, to mark it and then extend each at a perpendicular angled to form a square. Hopefully someone knows the feature I am talking about and how to either get it back or turn it on again.
Thanks,
Max
(sorry if this is dumb I am somewhat new to autocad!)