Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

Text different between our drawings and vendor drawings

Thomasbatson
Collaborator

Text different between our drawings and vendor drawings

Thomasbatson
Collaborator
Collaborator

We are using 2021, I am a normal ACADE user but have a text question.  I use standard notes normally, I pasted them into a vendor drawing and they were looking weird.  To test, I open a new drawing, copy those notes from the vendor drawings to our normal template and they look fine.  As you can see in the image there is 1 note where the FURNISH looks different than the note above it even though they are both ROMANS and .0938 size.  I am just not too familiar with this so hoping someone has some suggestions for me to look at.

 

Thank you for the help.

0 Me gusta
Responder
Soluciones aceptadas (3)
967 Vistas
11 Respuestas
Respuestas (11)

whitney_jeff
Collaborator
Collaborator
Solución aceptada

Thomas, your image was not uploaded.

Sometimes in MTEXT the style/font of the text can be different from the actual defined text style.  Open the text and highlight/select the word and the font will be shown.  That may not be the case here

0 Me gusta

Thomasbatson
Collaborator
Collaborator

Oh crud, sorry...attached.

0 Me gusta

Thomasbatson
Collaborator
Collaborator

And, meant to press reply not accept.....I did open the text and highlight them and they both say ROMANS and .0938

0 Me gusta

whitney_jeff
Collaborator
Collaborator

Yeah, check the properties in both mtexts, looks like one is actually bigger than the other

0 Me gusta

whitney_jeff
Collaborator
Collaborator
Solución aceptada

Check the character width too - on the text formatting bar it's the last drop down on the right

 

0 Me gusta

Thomasbatson
Collaborator
Collaborator

Highlighting them both and displaying the properties shows that most everything is the same except the contents and position.

0 Me gusta

whitney_jeff
Collaborator
Collaborator

can  you post the actual vendor dwg? (in version 2019 or below?)

0 Me gusta

Thomasbatson
Collaborator
Collaborator

Yes, attached

0 Me gusta

whitney_jeff
Collaborator
Collaborator
Solución aceptada

The character width in the 2nd note is 1.00, and in the first note it is 0.800.  Change them both to 1.00 or 0.800

0 Me gusta

Thomasbatson
Collaborator
Collaborator

Oh, I kind of thought that was in the properties tool bar, I didn't actually use the drop-down in the formatting panel.  Sorry to be a little dense, just anything outside of electrical I flounder a little bit.  Thank you for the great help.

0 Me gusta

whitney_jeff
Collaborator
Collaborator

No problem, glad I could help.  Tons of things I don't know in ACAD!

0 Me gusta