Spin, Roll and Tilt are not working with 3DConnexion

[LyleHardin]

Tried to use my 3D Connexion Navigator to AutoCAD 2016 today. First time in a few years.

The pan and zoom works, but the Spin, Roll and Tilt are not working.

Under options and settings everything is checked like it should be.

Any ideas

[wispoxy]

Does it happen per .dwg or just one file?

[Alfred.NESWADBA · Accepted solution]

Hi,

already handled in the parallel thread >>>there<<<

- alfred -

[LyleHardin]

I remember this happening. The double post, that is.

Either the forum or my browser was acting up and wasn't responding after I hit post.

I checked the forum and didn't see my post, so, of course, I tried it again.

Later that day I saw them both and at the time I didn't see how to delete it.

[LyleHardin]

BTW, turns out it won't Tilt and such if the drawing is in a "2D Wireframe" visual mode.

Odd. Understandable, I guess, but odd. Why would they do that?

[JDMather]

---

@Anonymous wrote:

... in a "2D Wireframe" visual mode.

Odd. Understandable, I guess, but odd. Why would they do that?

---

Let's assume you were in a 2D app like MS Word.  

You would expect pan and zoom to work, maybe rotate, but not tilt, otherwise you would be looking at the edge of the sheet of paper.

Same thing on a 2D drawing sheet.  So a bit of logical intellegence built into the driver.