Ortographic View

[umitsukorkmaz]

Hello everyone, I am new to Autocad and trying to learn how yo draw ortographic view. Can someone help me with the attachement my teacher was not helpful at all:/

[imadHabash]

Hi,

We have here 3 main clear view ( Top , Front and Side ) . Draw the top view in the upper left side. Then draw the front side below the top view ( Lower left ) ... then draw the side view beside the front one ( Lower right ).

Note: You can start drawing views depending on rectangles (squares ) ... I mean , count them in the 3d shot view.

[pendean]

@umitsukorkmaz You don't have any dimensions or grid sizes shared, so you might not have all the instructions needed to finish your homework.

In the meantime... here is a good online tutorial

https://www.mycadsite.com/tutorials/level_1/orthographic-projection-in-AutoCAD-tutorial-1-12.html

[Patchy · Accepted solution]

Count the squares.

[umitsukorkmaz]

She literally just sent this picture.. I have no idea how to find the dimensions and my brain can not comprehend how to understand the views 

[Patchy]

Search for it on the internet, so easy to learn.

Imagine had to go to the Library or Book Store to find the instructions decades ago.

[imadHabash]

>> ... I have no idea how to find the dimensions

Follow the above previous solutions and you will make it. Just start and get back here to check your tries.

[Washingtonn]

You do not have enough information about the areas indicated to complete the assignment. You can make assumptions but... Maybe the instructor wants students to ask about these areas - which shows they understand Orthographics?

[umitsukorkmaz]

Hello again, I think I did the top view just fine but i am struggling with the other 2. Can someone guide me please?

[@umitsukorkmaz - This post was merged in from a new post created on the same topic.]

[Patchy]

Something like this:

[Washingtonn]

As mentioned in the earlier post on the same topic, you don't have sufficient information to complete the required views. There are many orthographic views that could be generated based on the original post - all equally valid and all based on assumptions because of the lack of information. Below are just a couple of plan view solutions (red lines are hidden lines) along with a 3D view of the actual solid. The actual solid used corresponds to the far right top view (or maybe not....)