No aplicable
03-22-2018
02:19 PM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
i have just been upgraded from autocad 2016 to 2018 and found the "center line" command (from 2017 )
i found the system variable commands , but from what i can figure out they have to be set on everysheet i use the center line command.
is there a way to set / change the "base" system variables so when i use the center line command the system variable stay constant when i switch sheets and not have to change it every time
¡Resuelto! Ir a solución.