- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
Hi everyone,
Can someone please guide me in the steps required in order to lay this phone model flat on the X-Y plane?
¡Resuelto! Ir a solución.
The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.
Hi everyone,
Can someone please guide me in the steps required in order to lay this phone model flat on the X-Y plane?
¡Resuelto! Ir a solución.
ALIGN command will step you through selecting a source point on the phone and a target point in the XY plane: from the endpoint on the edge of the phone to the endpoint of that line in the model, then from another endpoint or nearest on that same edge of the phone to the other endpoint of that line, then from the other edge of the phone to point "FROM" a corresponding endpoint of the line.
Hi @masterenol,
Check out the 3Dalign command