Hatch selection problems
No aplicable
07-29-2016
04:34 AM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
Has anyone had similar problems to this?
I have a drawing, parts of which have been imported from and architectural plan, where I am adding my work.
If I try to hatch sections of my work I get messages such as "selecting all".
If I move the items into a blank section of the drawing and hatch them, it works no problem and then I can move it back to the correct place.
I have never had this before and I assume it is a setting in part of the drawing that was imported?
Thanks if you have any insight!
John