No aplicable
11-04-2018
07:57 PM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
I have made a drawing inside a 420 to 297 rectangle in model view, created a new layout with a single viewport selected to fit and set the page setup parameters as in page-setupt.png. The problem is, the rectangle does not fit perfectly in the layout as seen in layout.png and this shows when the layout gets exported in PDF. I know I am missing something rather simple but could not figure it out.
¡Resuelto! Ir a solución.