- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
Annotation scale of current view is 1:1; required scale is metric, with a scale factor of 25.4 for 1:1.
Current drawing units is decimal.
I begin by creating the top of a bolt head, which is a line 1.06 units in length. The scale looks very small, so I increase the 1:1 scale by 25.4. That looks better, but when I use DIMLINEAR to check the length I get 27 units instead of 1.06. I know that 1.06 X 25.4 is 26.92. Not only am I getting the wrong units, but the dimension is also displaying the units to the nearest whole number. What am I doing wrong?
¡Resuelto! Ir a solución.