Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

Cóno Excéntrico

damacylo
Advocate

Cóno Excéntrico

damacylo
Advocate
Advocate

Hola

Alguien sabe cómo se crea un cono sólido excéntrico truncado?

Probé con el comando SWEEP y no me da

Cualquier duda al jpg attached.

Muchas Gracias

Daniel Avila
Hydraulic Eng.
0 Me gusta
Responder
1.005 Vistas
3 Respuestas
Respuestas (3)

Kent1Cooper
Consultant
Consultant

[as in the other old thread....]  LOFT.

Kent Cooper, AIA
0 Me gusta

damacylo
Advocate
Advocate
Thank U again Kent
I did it (the oblique cone)
I take the opportunity to ask you, What are the difference between the LOFT and SWEEP 3DTools commands?
Daniel Avila
Hydraulic Eng.
0 Me gusta

Kent1Cooper
Consultant
Consultant

@damacylo wrote:
.... What are the difference between the LOFT and SWEEP 3DTools commands?

 

I can't tell you anything more about them than Help will -- read about them there.

Kent Cooper, AIA
0 Me gusta