Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

cannot revolve object

Anonymous

cannot revolve object

Anonymous
No aplicable

Hello:

 

Thank you for helping me, I have one  more problem about "revolve". I tried to revolve the yellow object, and choose the yellow object at first, then I specifie two points on the red line so the yellow object can revolve around the red line, but it still not working? I re-upload the file. 

 

What I did is that 1)type "revolve" in the commad 2)select yellow object and then enter 3) Specify two points on thered line and then enter. I don't know what is wrong with my steps? Can you please try to revolve the yellow object instead of building a new one because I am going to combine the object in layer 1 with object in layer 0 (I turned the layer 0 off)? Thank you so much!!!

 

Best!!!!

 

Edited by
Discussion_Admin

Responder
Soluciones aceptadas (2)
5.209 Vistas
4 Respuestas
Respuestas (4)

Sofia.Xanthopoulou
Mentor
Mentor

Hi @Anonymous,

 

you don't do anything wrong. Seems that the Spline is not accepted. Please explode the Spline object and revolve.

 

Regards

 

-----------------------------
Please accept as solution if my post fully resolves your issue, or reply with additional details if the problem persists.

 

0 Me gusta

Alfred.NESWADBA
Consultant
Consultant
Solución aceptada

Hi,

 

there are some points double in your spline (control point 19 and 20 as well as 1 and 2), these are critical situations and should be avoided.

At the moment you remove these 2 points command _REVOLVE will be happy to present you a valid result :cara_guiñando_un_ojo:

 

- alfred -

------------------------------------------------------------------------------------
Alfred NESWADBA
ISH-Solutions GmbH / Ingenieur Studio HOLLAUS
www.ish-solutions.at ... blog.ish-solutions.at ... LinkedIn ... CDay 2025
------------------------------------------------------------------------------------

(not an Autodesk consultant)

Anonymous
No aplicable
Thank you for helping me, i just do not understand how to check if my points are crossing and how to remove the additional points. In additional, I don't know how to check which points are 19 or 20 and 1 or 2?
0 Me gusta

Alfred.NESWADBA
Consultant
Consultant
Solución aceptada

Hi,

 

>> I don't know how to check which points are 19 or 20 and 1 or 2?

Select the object then look to the properties Window, there you have the chance to step through the vertices/control points and every selected point gets a marker:

To step forwards and backwards use the small arrows on the left side of the field with arrow up/down symbol.

 

20160416_0928.png

 

>> and how to remove the additional points

Start command _SPLINEDIT, select this spline, then use option Edit vertex ==> Delete

 

- alfred -

------------------------------------------------------------------------------------
Alfred NESWADBA
ISH-Solutions GmbH / Ingenieur Studio HOLLAUS
www.ish-solutions.at ... blog.ish-solutions.at ... LinkedIn ... CDay 2025
------------------------------------------------------------------------------------

(not an Autodesk consultant)