No aplicable
03-28-2021
01:01 PM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
i have to make lots of floorplans, for example: i start with the the outside wall, I offset this polyline and close it with 2 polylines at each side.
after i have made the wall all around the floorplan I will have to put in the windows, doors ect, but they are not made with a wipeout frame, i am not allowed to use this, so i have to break the polyline walls and place the door, and again i would have to connect the pl's again with 2 pl's at each side so the pl's are closed again. is there an easier way to do this of a lisp or something that would speed up my drawings?
¡Resuelto! Ir a solución.