Community
AutoCAD Forum
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

AutoCAD - Seeking press pull bug workaround

2 REPLIES 2
Reply
Message 1 of 3
20055423ZY6Q8
343 Views, 2 Replies

AutoCAD - Seeking press pull bug workaround

20055423ZY6Q8
Explorer
Explorer

Will not extrude an area, sometimes will not extrude two areas in the drawing.

 

Is there a leaky sketch fix tool?

 

[ The subject line of this post has been edited to include the product name by @handjonathan ]

AutoCAD - Seeking press pull bug workaround

Will not extrude an area, sometimes will not extrude two areas in the drawing.

 

Is there a leaky sketch fix tool?

 

[ The subject line of this post has been edited to include the product name by @handjonathan ]

Tags (2)
2 REPLIES 2
Message 2 of 3
TheCADnoob
in reply to: 20055423ZY6Q8

TheCADnoob
Mentor
Mentor

When i redraw this line it seems to work fine. 

 

TheCADnoob_0-1666099715152.png

 

 

TheCADnoob_0-1666099660140.png

 

 

 

CADnoob

EESignature

When i redraw this line it seems to work fine. 

 

TheCADnoob_0-1666099715152.png

 

 

TheCADnoob_0-1666099660140.png

 

 

 

CADnoob

EESignature

Message 3 of 3
vinodkl
in reply to: 20055423ZY6Q8

vinodkl
Mentor
Mentor

Hi @20055423ZY6Q8 

 

you can create a boundary of the area and then use than boundary to extrude. See below screencast 🙂

 

--------------------------------------------------------------------------------------------------------------------------
ವಿನೋದ್ ಕೆ ಎಲ್( System Design Engineer)



Likes is much appreciated if the information I have shared is helpful to you and/or others.

Please mark "Accept as Solution" if my reply resolves the issue or answers your question, to help others in the community.
--------------------------------------------------------------------------------------------------------------------------

Hi @20055423ZY6Q8 

 

you can create a boundary of the area and then use than boundary to extrude. See below screencast 🙂

 

--------------------------------------------------------------------------------------------------------------------------
ವಿನೋದ್ ಕೆ ಎಲ್( System Design Engineer)



Likes is much appreciated if the information I have shared is helpful to you and/or others.

Please mark "Accept as Solution" if my reply resolves the issue or answers your question, to help others in the community.
--------------------------------------------------------------------------------------------------------------------------

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

AutoCAD Inside the Factory


Autodesk Design & Make Report