Community

Auto Spell Check

Auto Spell Check

JAY_00
Contributor Contributor
1,144 Views
2 Replies
Message 1 of 3

Auto Spell Check

JAY_00
Contributor
Contributor
‎02-10-2022 05:37 PM

The spell check in my AutoCAD seems to not not be working. The squiggly red line underneath an incorrectly spelled/unrecognised word is not showing up in my mtext or single line text when I type. Is there a setting that fixes this? I only noticed that it disappeared in the las week. 

0 Likes
Like
Report
Accepted solutions (2)
Solution 1
Solution 2
1,145 Views
2 Replies
Replies (2)
Message 2 of 3

ennujozlagam
Mentor
Mentor
‎02-10-2022 06:19 PM
Accepted solution

https://knowledge.autodesk.com/support/autocad/learn-explore/caas/sfdcarticles/sfdcarticles/Spell-ch...





Remember : without the difficult times in your LIFE, you wouldn't be who you are today. Be grateful for the good and the bad. ANGER doesn't solve anything. It builds nothing, but it can destroy everything...
Please mark this response as "Accept as Solution" if it answers your question. Kudos gladly accepted.
0 Likes
Like
Report
Message 3 of 3

vinodkl
Mentor
Mentor
‎02-10-2022 07:05 PM
Accepted solution

Hi @JAY_00 

When editing the mtext in the text editor ribbon make sure that the "spell check" is highlighted blue or when editing the mtext you can also right click on the text and then go the editor settings and checkmark "spell checking" 🙂

--------------------------------------------------------------------------------------------------------------------------
ವಿನೋದ್ ಕೆ ಎಲ್( System Design Engineer)
Likes is much appreciated if the information I have shared is helpful to you and/or others.

Please mark "Accept as Solution" if my reply resolves the issue or answers your question, to help others in the community.
--------------------------------------------------------------------------------------------------------------------------
0 Likes
Like
Report
Report a website issue