No aplicable
05-12-2016
12:09 PM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
I've experienced several issues.
- In paperspace, my dimension lines and the lines within the viewport are shown misaligned. Image attached. If I zoom in and out, it usually corrects.
- Xline - When I try to draw from point to point, it seems constrained to some random angle and will change to another random angle when I get near a hot point. Sometimes it helps to zoom in and out but not always.
- I've had an xref disappear and no, I did not delete it. It was shown as loaded but was nowhere to be found. Not on a frozen layer. I detached and attached again. No problems since.
- I've had an xref view doubled and offset. The parent file was correct. I reloaded, restarted file, and restarted CAD. I finally detached and attached again. No problems since.
- I'm often waiting on CAD catch up to my commands and clicks, but not always.
- It takes ACAD a million years (ok 3-4 minutes) to shut down. Meanwhile, my computer is completely bogged down.
I'm not running too many other programs at the time.
I updated to 2016 from 2014 about a month ago.
Any advice.
.
¡Resuelto! Ir a solución.