Last week, The bond in our plotter at work was switched to 24" from our normal 36". Since then autoCAD has only been plotting half of the page when i try to plot.
Here is where it gets tricky.
-What is printing is NOT running of the page, it stopping halfway across the sheet in a proportion that would make sense to what I am printing.
-In Page setup manager I have switched from ARCH D Landscape to ARCH D portrait.
-I have gone through my print settings and everything appears to be correct, I have printed in this format before manytimes, this seems to be an isolated incident.
-It is also doing this when I try to print PDF's at this size
Does anyone have any thoughts?
Is there any useful information I may have left out?
Thank you.
