Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

How can I get isometric and orthographic views?

Anonymous

How can I get isometric and orthographic views?

Anonymous
No aplicable

I have a fully made 3D object and I want to make isometric and orthographic views (Top,Front and Side).

I think it uses Layout but I'm not fully sure of how to make them.

Also is it possible to make some writings at the corner as shown in the photo below?

 

fc4a694242721.5601db730c3df.jpg

0 Me gusta
Responder
Soluciones aceptadas (1)
1.379 Vistas
1 Respuesta
Respuesta (1)

maxim_k
Consultant
Consultant
Solución aceptada
Hi,

In AutoCAD for Mac you can use SOLVIEW - SOLDRAW commands combination to accomplish this task.
Than you can put annotations in the Layout.
Here are two links to short tutorials about SOLVIEW -SOLDRAW :

https://m.youtube.com/watch?list=PLbZdxvrsUOyw9E1ZRq2Ibfdh1AIFHwJDC&v=U6VM06GSLWg

https://m.youtube.com/watch?list=PLbZdxvrsUOyw9E1ZRq2Ibfdh1AIFHwJDC&v=DatDMl6X3SA

Maxim

Do you find the posts helpful? "LIKE" these posts!
Have your question been answered successfully? Click 'ACCEPT SOLUTION' button.


Maxim Kanaev
Architect
MARSS

MacACAD | Linkedin

Etiquette and Ground Rules of Autodesk Community