Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

Degree direction messed up

Anonymous

Degree direction messed up

Anonymous
No aplicable

No matter what command or option I set, Autocad LT will always set 90 degrees south and 270 degrees north. It always revolves clockwise and it's driving me draving my crazy.

 

I've tried angdir command set to 0, no good

In the Units tab the angle direction is not set to clockwise but still is clockwise.

0 Me gusta
Responder
452 Vistas
5 Respuestas
Respuestas (5)

maxim_k
Consultant
Consultant
Welcome to Autodesk Forums!

Hi,

Does this happens in all drawings? Or just in one?
Have you tried to restart AutoCAD (quit it with QUIT command and launch again)?

Maxim

Do you find the posts helpful? "LIKE" these posts!
Have your question been answered successfully? Click 'ACCEPT SOLUTION' button.


Maxim Kanaev
Architect
MARSS

MacACAD | Linkedin

Etiquette and Ground Rules of Autodesk Community
0 Me gusta

Anonymous
No aplicable

Yes, it happens with all drawings. I've tried un-installing and re-installing.

 

0 Me gusta

maxim_k
Consultant
Consultant
What about reset? Have you tried to reset AutoCAD options from the Application tab of the AutoCAD preferences?

Maxim

Do you find the posts helpful? "LIKE" these posts!
Have your question been answered successfully? Click 'ACCEPT SOLUTION' button.


Maxim Kanaev
Architect
MARSS

MacACAD | Linkedin

Etiquette and Ground Rules of Autodesk Community
0 Me gusta

Anonymous
No aplicable

Yes behavior is the same after a prefrence reset

0 Me gusta

maxim_k
Consultant
Consultant
Are you sure you are using correct UCS in your drawings?

Maxim

Do you find the posts helpful? "LIKE" these posts!
Have your question been answered successfully? Click 'ACCEPT SOLUTION' button.


Maxim Kanaev
Architect
MARSS

MacACAD | Linkedin

Etiquette and Ground Rules of Autodesk Community
0 Me gusta