Electrical Report Audit

[Anonymous]

I'm running a report audit and an error shows that none of my wires are connecxted. How can I fix this situation? I'm doing a power page with motor circuit with differnt HP and I run the audit and it shows no wire connection. Any help would be greatly appreciated.

[rhesusminus]

Well, normally, AcadE is correct here. The reasons for it to say so are different, but if you could upload a drawing here, we could have a look at it.

Are you using custom symbols, or AcadE standard symbols? If you're using custom symbols... are the connection point located in the right place?

THL

[Anonymous]

I use custom symbols, but I guess that the insertion points could be off. I'm really new at using ACE. My forte is in Architectural, and I'm training myself too. So, with that in mind; I'll submit a dwg. so that you can see exactly what is going on. Thanks for the help.

Michael Goolsby

[rhesusminus · Accepted solution]

Hello again Michael.

Only problem I can see, are the wires ending in the table at top. These are, of course , not connected. Also, the earth symobl (4AWG_GND) is not a real AcadE symbol, hence, you'll get en "wire not connected" error on that too.

Wel.. there was an error for the wire that goes to MS11:L3. I just deleted the wire, and redrew it. Easier and quicker than trying to re-connect the wire loop thingy.

Also.. the connection point for MS11:L3 (the block HDV1_024) are also i bit off to the left. See attached screen shot.

Are you getting more errors in Electrical Audit than this?

THL

[Anonymous]

Thank you for the help. I went through the doc and reconnected the wires that were not connected. I also found that when the the 3ph ms was drawn it was off by .0027" and was caausing problems. Thank you for the help.

Michael Goolsby