window section in plant

[Anonymous]

Good morning, why on the plant can I see the section of the doors but I can't see the section of the windows? It also happens that when I copy the plant in another file the windows are not copied. Thank you.

[David_W_Koch · Accepted solution]

Change the cut plane height from 2,100 to 1700.00 and the Windows will show up.  I am guessing that ACA interpreted the comma as a decimal point and put the cutplane 2.1 mm above the floor line, well below your Windows.  1700 mm is pretty high for a cut plane, but you have some Windows with sills at 1600 mm.  You could set it slightly above 1600 and still have the Windows be cut properly.  If that causes problems elsewhere, you can set the cut plane lower and override the cut plane on the Walls with the Windows with higher sills.

[Anonymous]

Perfect. Thank you very much.