Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

Walls not Visible

Anonymous

Walls not Visible

Anonymous
Not applicable

I created a 240 MM thick outer wall by copying diffrent componets from wall styles into new wall callled OZ 240-Brick veneer because I could not find exact 240mm wall for my project. Every thing was fine  (I created elevations and views without any problem.) untill I created sheets in project Navigator where error ".. can't disply..contains no geometry.."

I'm nit sure but it appears problem is caused by the creation of this OZ 240...   wall style.

Any one please help me here I just can't start from scratch or even I wanted to there is no 240 brick vaneer wall tool available.

Thanks in Advance.

Instructions for dummies plz as I'm very newbe to Autocad Architecture 2015.Wall Style created from standarad style.PNG

 

0 Likes
Reply
990 Views
9 Replies
Replies (9)

leothebuilder
Advisor
Advisor

We will need some more information to help.

When using the Project Navigator, did you create named views on the VIEWS tab and are you placing those views onto sheets?

How high are your new 240 brick veneer walls, and what height is your cut plane set to?

 

Is is possible to attach the drawing files (zip the whole project).

 

It's difficult to figure out what the problem is without seeing the actual project files.

0 Likes

Anonymous
Not applicable

, Thanks a lot for replying to my post.

I recreated the constucts, Views and a sheet and similar problem again

 

Plz find below attached project file.

I appreciate the help. As I said I'm very beginer to this all.

0 Likes

Anonymous
Not applicable
When I dragged views into newely created sheet following error appears;
"The Element can not be placed because it contain no geometry"
0 Likes

Anonymous
Not applicable

Sheet Error.PNG

0 Likes

leothebuilder
Advisor
Advisor

Your project works as expected.

I had no problem dragging the named views onto a sheet.

I noticed your Floor Plan file in the view tab did not have a named view. I created one and had no problem dragging onto the sheet.

0 Likes

Anonymous
Not applicable

Sorry for takingup your time. I'm still facing the same issue of ...no gingeometry ... error. I'm arraching the file again with views which I created/recreated but to no avail.  i am using autocad architecture 2015 and 2016.

Possible if you could arrach the file that you created the sheets plz.

Thanks in advance.

0 Likes

leothebuilder
Advisor
Advisor

Again, your project works fine.

You need to make sure you are dragging actual NAMED views onto the sheets............see attached.

I noticed that the Floor Plan did not have a named view so I created one for this example per attached PDF.

The named elevation and section views were created with the elevation and section tools you used from the tool palette.

0 Likes

Anonymous
Not applicable
I'm just about to pull my hair out in frustration! I could see your views and sheets but here I can not get the same. You dragged my created Elevations views but I can not do the same. I get error ...North View can't be found" and it is the same case with other elevations whether I drag them individually or the main Elevation view.
May I ask how are creating views? I right click the View folder and create new view. I also try with Model space selection but to no avail.
I must thank you for putting up with me but I'm stuck.
0 Likes

Anonymous
Not applicable

Same Named views created by selecting Elevation fron callouts as you suggested. i could open these views fine by double clicking but ca not drag onto sheets and following error comes up every time.

Followed a procedure from a book and same problem.

 I'm not sure what I'm doing wrong. Appreciate any lead to fix it.

0 Likes