abbrechen
Suchergebnisse werden angezeigt für 
Anzeigen  nur  | Stattdessen suchen nach 
Meintest du: 

UPN profile with baseplate and place of anchors

UPN profile with baseplate and place of anchors

Hello if i create a baseplate on a UPN profile the anchors parellel to profile will placed from centre of the flanch of the UPN.

With a HEA HEB HEM profile it is going ok off course, but with a UPN this is not a good dimension point.

So it will be a fine improvement if there is a possibility that the anchors can be place from the outside of the profile also.

In the connection "Single side endplate" it is possible to set this dimension point on the outside of a  UPN profile. (see attachement dimension 35 mm) So it has to be also possible in the baseplate connection.

 

regards

Carlo Heisterkamp

Can't find what you're looking for? Ask the community or share your knowledge.

Idee einsenden  

Autodesk Design & Make Report