Scribe line/Etch latout to a beam

[Anonymous]

I'm only relatively new to Advance Steel so i'm hoping this might be a simple question.

As standard, Advance Steel seems to mark a scribe line/etch at the 4 corners of a cleat welded to a beam. What I would like to mark is the bottom side of the cleat and where the center line of the cleat falls on the beam. So basically, just 2 lines on the beam: a vertial and a horizonal.

How can i achieve this?

Cheers.

[múinteoir]

Not sure if this is possible, there is an option in Management Tools to switch from a partial line to a full outline of the position. See below