Inventor 2013 was working just fine until I installed SP1.1 X64. Now it just locks up the second I try to access the application options.
Solved! Go to Solution.
From system, there is only one CER submited at 10/31/2012, which is afte Inventor 2013 Sp1.1 launched. This CER does not contact with any defect, it sounds a random one as you described.
Does Inventor crash in later time? Could you repeat the steps?
I'm getting the same problem. Inventor works just fine until I click on Applications Options. Then everything freezes. I am using a HP laptop.
Any suggestions on what's causing this.
This used to work, can not remember the last time.
BUT SYSTEM NOW FREEZES WHEN HITTING APPLICATION OPTIONS
NEED TO CLOSE PROGRAM USING SYS MAN TO REOPEN
XPS 1710 DELL LAPTOP - WIN 7 ULTI
STILL NOT WORKING
STILL NO GOOD
RUN **** AMINISTRATOR
STILL NO GOOD
As LarrenSmoot said, normally this crash issue happens at the a specail use account, try to log in software as local computer's administrator to check issue still exist or not. If issue disappared, please check the special user account profile, otherwise, could you submit the CER to analysis this issue? We could not reproduce it at our site.
OK - IT WILL WORK IF I LOG IN AS ANOTHER ADMIN USER ???
WHAT DO I NEED TO RESET, CHANGE, LOOK AT ???
Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register
Start with some of our most frequented solutions to get help installing your software.