Not had a problem before with this but I can't get a decal to appear in the rendered o/p in inventor studio!
it's there on the part and the assembly but not when rendered????
Any clues anyone?
IV RS 2011
Works here.. Any chance you have the image on the wrong side of the face?
Try putting the assembly w/decal into a shaded idw and seeing if it shows up.
dumb question... have you actually decalled the image or just left it in a sketch? you have to apply the image to a surface with the decal command to get it to render.
Thanks for the replies....
Definately a proper decal, I've not had this problem before!
Decal also appears in a shaded IDW view.
Try giving the decal a 0.0005 offset from the surface. See if it shows up then. I've had them get lost in surfaces on rare occasions.
OK... I've got it, it came back to me in a flash!
The Image was to big! it was at 300 DPI so the file size was about 15Mb, I took it down to 150 DPI and it worked.
I've actually been here before a while back but it had totally slipped my mind!
Thanks anyway guys
Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register
Start with some of our most frequented solutions to get help installing your software.