My Autodesk Simulation cfd 2014 don't open, because have to write the computer name or ip,but I put and appear the message saying : erro 1.360.0 and other erro.I don't no what I do
Welcome to the forum. You will want to ensure your license server software is installed and configured corectly. You can refer to the guide linked below for instructions
Commonly, if you are running the license server on same same system as the product being installed, you may encounter a failure to connect to the server. This is because Windows 7 responds internally using ipv6 and the license manager you installed is likely the ipv4 version. To work around this issue please load the site linked below below and run the fix-it called "Prefer IPv4 over IPv6 " found about halfway down the page. Once that is complete, please reboot the system and try launching the product again.
Welcome to the community.
If you have a network licensed seat, then you need to install and configur your license manager and point your software to that license manager.
For a Quick-Start Guide on configuring the Autodesk License Manager, please see my post for further information:
Post any screen shot errors that you get here.
Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register
Start with some of our most frequented solutions to get help installing your software.