Installation & Licensing

Posts: 3
Registered: ‎03-18-2004
Message 1 of 2 (62 Views)

Conversion problems

62 Views, 1 Replies
03-18-2004 12:26 AM
I am seeking if there are any conversion problems when switching all releases of AutoCAD (lite) to the newest release of AutoCAD (lite), but can't find any info, Where can I find this info? and if there are problems what can we do about it? I just need to know the headlines of these possible problems.

releases we use

13, 14, 15, 2000(i), 2002 (I) and 20004

could you help me?
Distinguished Contributor
Posts: 924
Registered: ‎10-27-2003
Message 2 of 2 (62 Views)

Re: Conversion problems

03-22-2004 12:21 AM in reply to: Dreeke
If you only have DWG and block's, there will be no convertion problems.
If you have applications (Lisp, VBA, ) you should migrate them also, and that can be a problem.
Just give the end-users a good upgrade training on the basic drawing things like Polar and Tracking, so that they will realy use the new features that gain time.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Connect with Us