I tried to reverse the steps, and gain a better result i think.
first: insert a blind at the end of a line,
then, insert a flange connection, but not accurate
both them can get the properties of line.
Give this a shot:
Edit the Piping Fittings --> Flange Connection symbol/block
Where it has the end connections, select the Point Parameters and replace the text for the Position name to:
and for the other Point Prameter:
The is imitating they naming convention used for inline valves.
Hope it works for you.
Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register
Start with some of our most frequented solutions to get help installing your software.
The AutoCAD P&ID forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.
|AutoCAD P&ID General|