AutoCAD 2013/2014/2015

Posts: 3
Registered: ‎01-12-2013
Message 1 of 2 (143 Views)

Problems with hatching Xref layer

143 Views, 1 Replies
01-12-2013 09:42 AM

I'm a beginner with AutoCAD and doing some homework for school where am supposed to use different xref map layers just to learn. The problem is when I adding an image and place it with align the other layers aren't visible anymore. So when am go to "hatch" and adjust the transpaercy the others layers are visible like I want, but I can't confirm the command. It says; "do you really want to do this?". I push enter but then the transparecy dissapear. Any idea whats wrong? Might it have something to do with layers or anything like that? I tried to make the xref into layers but i'm not sure I succeeded.


Thanks for any help.

Posts: 3
Registered: ‎01-12-2013
Message 2 of 2 (112 Views)

Re: Problems with hatching Xref layer

01-14-2013 02:45 AM in reply to: Noway123


You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you interested in helping shape the Autodesk Community?
We’re looking at a few different ways to improve the “All Forums” landing page and need your feedback! If interested, please take a few minutes to fill out the following Usability Study. Thank you for your time!

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Connect with AutoCAD