I have been trying to figure out how and if I can put a miter on the end of a 3D solid cylinder, I am trying to draw a tank that has a 10 degree sloped bottom with a 1" radius fillet around the bottom at the sloped end. I have been trying to do this for afew days now.
Solved! Go to Solution.
One method is to create half the profile of the tank in 2D, then revolve. or just revolve a 1inch radius arc and a 10 degree line into a surface you can use to slice off the bottom of the cylinder
I have been able to draw the tank bottom at a 10 degree slope and have also been able to put a 1" fillet on it, my difficulties have risen in trying to draw the tank shell with the 10 degree slope on it. I shall try you solution for the tank shell.
I need to miter this 3D cylinder to mate up to the tank bottom I have alreay drawn. The attached file shows where I currently am in the process.
Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register
Start with some of our most frequented solutions to get help installing your software.