AutoCAD 2004/2005/2006

Reply
Contributor
Posts: 20
Registered: ‎03-21-2012
Message 1 of 2 (287 Views)

changing insertion point of block

287 Views, 1 Replies
03-25-2013 11:15 PM

I have placed hundreds of rectangle blocks with the insertion point at top left corner in AutoCAD 2004.

After that i found a mistake of insersion point of that block is wrong. The correct insersion point is lower right corner.

Is any solution to change the insertion point with out displacing  the blocks.

 

Regards

Sudarsan

*Expert Elite*
Patchy
Posts: 6,155
Registered: ‎09-16-2009
Message 2 of 2 (272 Views)

Re: changing insertion point of block

03-26-2013 07:20 AM in reply to: sudarsann

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community




Connect with AutoCAD

Twitter

Facebook

Blogs

Pinterest

Youtube