arc to editable mesh - control the number of steps in the arc

[Anonymous]

If I draw an arc and later convert to an editable mesh, how do I control the number of steps in the arc?

the arc has a radius 32, start 90 stop 180 (products a 90 degree arc)

when I convert to an editable mesh, it has too many steps in the arc - I only want 12 steps

I've tried initially setting this in interpolation of the arc, but nothing happens?

[Anonymous]

So I've can control the steps now - I restarted the project and steps does give me the control I want, in the INTERPOLATION section

New problem - when joining an arc to a line, and then creating an editable mesh from it, the join isn't smooth. Is there an automatic way to make the join smooth?

[Fadhil_Farook · Accepted solution]

For the last post, did you weld the two vertices before convert it to an editable mesh?

[Alfred.DeFlaminis]

Hello @Anonymous,

I believe @Fadhil_Farook is correct, welding those should help.  Did that work for you?

Best Regards,

[Alfred.DeFlaminis]

Hello @Anonymous,

I just wanted to follow up here, any progress on this issue?

Best Regards,