topic Re: create a mirage ruler in Visual LISP, AutoLISP and General Customization Forum

create a mirage ruler

k005 — Mon, 12 Jun 2023 18:01:22 GMT

Hello everyone

I want to create an automatic Mira ruler. can you help me with this? ( width: 6cm fix )

Height (cm) ? : 250

Direction (Front/Back): F

Specify point>

front

back

Thanks in advance for the help friend.

Re: create a mirage ruler

Sea-Haven — Thu, 15 Jun 2023 00:21:46 GMT

E Face staff ?

What is problem the level staff is a repeating pattern, bothe sides, based on the E face of 10mm solids not hard to make a block, array text & block. Edit text it would be a one off so it will take longer to write program than to do it.

PS a new one is $77.

Re: create a mirage ruler

k005 — Thu, 15 Jun 2023 03:10:31 GMT

Yes, you may be right. I thought of doing it as a dynamic block before I wrote a message...

However, if you want to add the Front/Back option, there must be two separate blocks. not very practical. so lisp code was my choice.

also if it happens with lisp code, I will add it to my program that I continue to develop in C #

yes, it seems a bit difficult... I think the friend who is available can help

Thank you.

Ynt: create a mirage ruler

k005 — Tue, 27 Jun 2023 10:47:01 GMT

Let me simplify the matter a little; It's just the front too...

Re: create a mirage ruler

Jonathan3891 — Tue, 27 Jun 2023 11:13:03 GMT

You can have one block and use visiblity states to have it show the front or back.

Re: create a mirage ruler

k005 — Tue, 27 Jun 2023 11:23:19 GMT

altitude is important. should be designed by entering this value. For this reason, the block may not be suitable.

Thanks.