topic Re: Load to mass problem in Robot Structural Analysis Forum

Load to mass problem

Anonymous — Wed, 20 Feb 2013 09:50:28 GMT

Hi,

When I try to convert load to mass, the program converts the loads that are applied on bars only, not those on shell elements.

Re: Load to mass problem

Artur.Kosakowski — Wed, 20 Feb 2013 09:56:22 GMT

Create a new load case where you have only loads applied to shells. Run static analysis of this case and check that the load is applied correctly. Then in the modal analysis mark disregard density and convert only the new load case to mass. Run calculations and check the total mass in the results of modal analysis case. If it is 0 then send us this model.

Re: Load to mass problem

Anonymous — Thu, 21 Feb 2013 13:23:47 GMT

Thank you Artur!