topic Re: ARC SLAB ON ARC WALL in Robot Structural Analysis Forum

ARC SLAB ON ARC WALL

risefire12 — Tue, 17 Jan 2023 23:17:12 GMT

Hi,
im trying to model arc slab on arc wall with arc discritizaton, but the joints are not connected to each other.

and also it give two joints at the same position

so what might be the problem ?

Romanich — Wed, 18 Jan 2023 12:38:27 GMT

You have a different discretization for arc segments:

Please check this topic.

risefire12 — Wed, 18 Jan 2023 14:21:12 GMT

Hi,
thank you very much for your reply.

i did set the discretization for floor to 7 same as the wall.. but still same problem

Stephane.kapetanovic — Wed, 23 Jul 2025 08:34:32 GMT

same way, split the circular edge into multiple arcs of the same radius and redo the vertical panels

Best regards

Stephane.kapetanovic — Thu, 16 Oct 2025 04:18:11 GMT

below, Split Arcs, a program to split all arcs of a contour, polyline, arc.

To use it, set the maximum length, select a contour (panel or cladding), a polyline or an arc and click ok

this program cuts each arc to the maximum length including if checked, the selected nodes.

Best regards

Released 26/09/2024

Rafal.Gaweda — Mon, 12 Jun 2023 08:59:51 GMT

Hi ,

added to the list: