topic Re: Pseudostatic forces ? in Robot Structural Analysis Forum

Pseudostatic forces ?

JoSaSo — Fri, 16 May 2014 10:15:58 GMT

Hey everybody,

I have a little problem. When I was making the model everything went great until I got to the point when reading the results. When I was reading the results from Diagrams table, *I tried to get nodal forces from middle of the slap by using pseudostatic forces alternative from reactions sheet. But it only gives me nodal results from the deadload case not the other cases at all ( and yes results are availevable and in maps-sheet they show pretty reliable results)

So... what's the problem, why doesnt it show nodal forces from other cases? Is it even possible to get nodal results that way from the panels?

Thanks pals

Re: Pseudostatic forces ?

Rafal.Gaweda — Fri, 16 May 2014 13:39:38 GMT

Pseudostatic forces - forces from a simple load case generated on the basis of a seismic or spectral analysis case mode.
Do not look at them for simple cases.

Nodal results are presented in Plate ans Shells Results table.

Re: Pseudostatic forces ?

Mohammed_Ata — Sat, 17 May 2014 18:25:33 GMT

with your reply , when i define a seismic load case . I check the Pseudostatic opton in reaction tab , there is no results on the screen

when i check reactions , the results are displayed on the screen .