topic Re: The load has not been distributed correctly in Robot Structural Analysis Forum

The load has not been distributed correctly

Anonymous — Wed, 04 Feb 2015 14:19:32 GMT

Dear All;

I've been through all the threads I could find - but still can't figure out why I'm getting the error above. "The load has not been distributed correctly - there are no objects or elements carrying the load overlap"

I've gone through all nodes, floor plates and cladding panels and made sure that they are accurate and coincident to 2 decimal places (using Rafal's Spreadsheet). All but 1 panel gets highlighted when I click on the error in the Calculation Message box.

I'm getting another error as well - 'Linear load has not been applied to a panel' .

Any help is much appreciated. Thanks!

Re: The load has not been distributed correctly

Rafal.Gaweda — Thu, 05 Feb 2015 11:19:40 GMT

File please.

Re: The load has not been distributed correctly

Anonymous — Thu, 05 Feb 2015 11:55:44 GMT

http://we.tl/GNpdNdtA1r

Thanks

Re: The load has not been distributed correctly

Rafal.Gaweda — Thu, 05 Feb 2015 12:40:18 GMT

The load has not been distributed correctly

Cladding loads are mainly used to apply loads to bars so if there are no bar of any reasons to transfer loads warining is displayed, although algorithm is capable to apply loads to panels edges.

See below

Re: The load has not been distributed correctly

Anonymous — Thu, 05 Feb 2015 12:57:11 GMT

Thanks Rafal.

I thought that would be the case as when I checked the Reactions by hand there was no loss of load.

Great to get confirmation though!

Would you be able to respond to the issue with Linear Loads not being applied to panels? (or would I need to start a new thread? - not familiar with forum etiquette - apologies).

Thanks.