topic Re: steel design error in Robot Structural Analysis Forum

steel design error

Anonymous — Wed, 18 Mar 2015 06:33:05 GMT

helo,

I want to take utilization for serviceability limit state. for that i have created a manual load combination. the calculations are completed. but when i go to steel member design, calculations and select the load comination case, then i m not getting utilization values at serviceability limit state. even though i select either serviceability or ultimate or both. it shows me message that i m showing. for different load cases i.e different cases on this same structure, it works well.

kindly help me.

Re: steel design error

Rafal.Gaweda — Wed, 18 Mar 2015 07:17:02 GMT

Check SLS settings for these bars

Re: steel design error

Anonymous — Mon, 30 Mar 2015 14:00:42 GMT

hello,

these are the settings to get member verification at SLS (serviceability limit state). but, i want results at ultimate limit state. here, i get utilization at ultimate limit state for different load cases, but here i hv created one manual load combination. it doesnt provide me any result or any message for COMB1 for ultimate limit state (uls) whe I select that load case in calculations list. i tried it for different design codes but it doesnt work. even it doesnt provide any message which i would correct. i want utilization at combination. what to do?

thx.

Re: steel design error

Rafal.Gaweda — Mon, 30 Mar 2015 14:15:57 GMT

SLS design works for SLS combinations.
If it is not the case please send us the file.

Re: steel design error

Anonymous — Mon, 30 Mar 2015 15:11:44 GMT

thx. i converted from sls to uls and it works.