topic Re: Mesh manipulation in Robot Structural Analysis Forum

Mesh manipulation

Anonymous — Sat, 09 May 2015 14:35:29 GMT

To whom it may concern,

I am having trouble manipulating the mesh for a model i have created. Everytime i want to remesh the software freezes. At the moment the mesh is unsymetrical therefore my results are too. I have attached the model. The problem area is the mesh around the pipe entry in the shaft. Could you please advice ?

Regards

Veronica

Re: Mesh manipulation

teixeiranh — Sat, 09 May 2015 18:45:03 GMT

Every time I try to change the mesh I get this:

Anyway, mind this issue please:

Is this normal?

Re: Mesh manipulation

Rafal.Gaweda — Tue, 12 May 2015 07:55:05 GMT

Crash should not appear on v.2015

It is recommeneded not to overlap panels , especially not overlap arcs with different discretization.

See below: